Universal K&F Concept 4 in 1 tripod E224A3 & BH-18
The complete small set arrives in a small neutral box. In addition to the basic tripod, there is a small bag made of a kind of Oxford material with which you can transport the tripod. A small plastic bag also contains a small Bluetooth trigger with the associated strap and a screw-on holder for the smartphone. An operating manual for the tripod in English and Chinese as well as a small manual for the Bluetooth trigger complete the picture.
The basic tripod weighs around 890g without attachments, which is quite light for such a tripod.
Optimally folded, you reach a length of about 32cm and a diameter of about 10cm. Ideal to take with you on hikes or excursions.
The three legs can be folded down in three stages (approx. 30°, 45° and almost 90°). In this way, a minimum height of around 35cm can be achieved. The legs have three extensions that can be pulled out and locked in place. So you can balance the tripod very well on sloping and uneven floors. A small spirit level on the tripod would have been ideal for this, but unfortunately it was not used. The rubber foot must be turned to the left, then all three extensions are released and can be adjusted. The set length is locked by turning it briefly to the right. However, the structure of the legs and the lock is kept quite simple and does not make a very stable impression. During the test, it happened to me again and again that a segment or even a whole leg pushed itself back in.
If you pull out the three legs fully and spread them slightly, you will reach a height of around 107cm. The middle rod can also be set in three positions. Locking and releasing also works as with the tripod legs. If the middle rail is also fully extended, you get a maximum height of around 168cm, which is quite impressive for such a small tripod. When fully extended, however, the low weight becomes noticeable, the tripod is not very stable and tends to wobble slightly, especially in strong winds. It is therefore not suitable for long exposures.
To attach a camera or lighting fixture, the tripod has a simple ball head that can be continuously tilted up to 90°. Compact cameras, small bridge cameras or at most one small system camera can be easily and securely mounted on it, heavier cameras such as DSLR or video cameras are definitely too heavy for the system.
If you loosen the lower cover on the center drive, the middle rod can be removed and used as a selfie stick or small monopod
A smartphone can also be attached using the included adapter. This can be mounted either horizontally or upright, for which two tripod threads are available on the adapter. The mobile phone is attached by spring action, the retaining clips are rubberized. A minimum of 6cm and a maximum of almost 9.5cm width can be inserted as a smartphone.
The included trigger is also intended for use with a smartphone. Using Bluetooth, it can be easily integrated into a mobile phone as an input device. The two applied triggers are labeled Camera 360 - IOS and Android, but both buttons have the same function. With my cell phone, the shutter release didn't work at first, only the zoom was activated. After trying out the camera settings, I found the culprit. You had to change the function of the volume buttons from zoom to shutter, then it worked without any problems.
