This kit does have everything you need and is the same as other ones to install. The hardest part is running and hiding all the wires. The picture is ok and clear, but with a 2” diagonal screen, do not expect a lot of detail when trying to get 2 or 3 views in. I like that it came with a 32GB micro-SD card. The inside camera could be wider angle or have the ability to adjust side to side rather than just up and down. Having the lighter plug power cable does simplify the install versus hard wiring the power, but also leaves more wires hanging around. If you are looking for something to record the front and part of the inside and not too concerned about screen size for seeing or viewing the back up camera, then this will work fine.

simply to use, green light comes on when connected!

use this as part of my PPI (Pre-Purchase Inspection) kit. It has a great screen that is very clear. I like the ability to take pictures and videos to avoid hassles. This allowed me to look deep into areas of the car to reveal damage and mechanical issues.

I mounted the kit on a lens with the 72 mm ring and it fits perfectly. It's easy to assemble and its operation is very simple, it doesn't require reading the instructions (I'd say it's better not to read them) just seeing the illustrations is enough. As for the quality of the product, it seems to be made with good materials and the finish is excellent; the polarizing filter holder is very effective, placing the filter well and with care and you don't touch it at all. There are two compartments for the square filters that I hope to get the most out of, I'm happy.
As for the optical quality of the filters, I can't comment because I haven't used them yet.

This has been a good kit and is nicely made. Thumb screw to lock on to lens ring is a bit poor. Threads are not smooth, therefore difficult to tighten and undo. Although the filter box is extremely well made, it is very heavy and I am looking for an alternative.

This magnetic filter kit is just great!
It includes a neutral density filter, an MCUV filter, a CPL filter and the magnetic adapter ring.
Little extra, the presence of the storage pouch that allows you to carry everything well without damaging it and which is also waterproof and small enough to be attached to the belt!
Quality is at the rendezvous, with each piece packed one by one in moisture-proof packaging.
Once in place, it is possible to leave the adapter ring since it does not hinder the putting of the cover in any way.
Then simply place the magnetized filter of your choice and that's it.
The effects are great, beautiful and high quality.
The fact that everything is magnetic is a real time saver!

This feedback will be given on initial discovery and has not been used in the field. The pinpointer gives a single green light upon FINDING the item, and increases to 3 lights when it is upon the item, so I hope that helps you understand my wording.

It found the penny 1" away, a nickel 3/4" away, a dime 1" away, and a quarter 1" away. But these were on a flat surface as the pinpointer approached from the side. If I hold these coins upwards so the pinpointer approaches the largest surface area, these numbers change:
Penny= 2"
Nickel=2"
Dime=1&3/4"
Quarter=2"

I, myself, am new to the hobby and will update with a proper review in a bit. Thanks for looking!

CO detector has a stand and shows CO level, green light, temp, and humidity. We set it up and after a couple days it started beeping as it was not plugged in. Not sure of accuracy of CO, but temp and humidity seem correct.